Flat Tube Nano Water Fuel Cell

WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer
WFC Wwater Fuel Cell Stanley A Meyer

Bridging the Assembly version map 

 voltage levels are in creased.  In S. Meyer-The Birth of a new Technology chapter seven page 15 Voltage Amplitude Switch-Off it states

 

"Voltage levels of Variance (Va xxx Vn) is achieved by simply switching-in or switching-out the member of Secondary Coil-cavities (505a xx 505n) (see 740 of Figure 7-13) in direct relationship to Taper Resonant Votlage surfaces (E9/10) of Figure (6-2) which acts and performs a

 

"Voltage Amplifier" when Compressional Wave-form (B) of Figure (7-12) is intensified at Exit Port 32 of Figure (6-2). Switching the member of Secondary Coil-Array (505a xxx 505n) maximizes electrical power transfer form Primay Coil (26) to Secondary Coil (52) by keeping the Voltage Amplitude of Pulse -train (49a xx 49n ~ T3 ~ 49an) constant."

Does the VIC from car have the taps in the secondary coil

to do this step increase or does he rely on just the tapered injector to do this.

Does the new VIC design have these taps? 

 

 If not, without tapered  tubes experimenters may not be getting the full effect of the stepped voltage increase.  I wondered where this was being done as I that not seen this discussed any where else or I just missed it.  I have notice the whole discussion of the timing and use of the pick up coil seems to be missing

It appears to me that latest VIC was a step to remove required adjustments - remove tabs, make cokes balance and fix voltage steps in tapered cells.

 

A good indication he was moving to getting ready production phase and out of development testing.

Cone coils have been suppressed from text books

Stan use injector  tip to do it as a wave guide
KISS was some thing Stan did Daily keep it simple stupid  most likely heard when things failed.

We have some impressive data our there Please have a read through this some what advanced document

Document Here